IT (integral)
SOP (slip-on welding, plate flange)Nominal pressure 5K, 10K, 10K thinThe pipe is slipped in and fillet welded. It is a flat plate with no hub and is the cheapest type. It is used for general low-pressure piping.SOH (slip-on welding, hub flange)Nominal pressure 5K, 10K, 10K thin, 16K, 20K, 30KA plate flange with a hub added to lower the stress at the root. Choose it where SOP does not stand the pressure or the repeated loading.SW (socket welding flange)Nominal pressure 5K, 10K, 16K, 20KThe pipe is pushed to the bottom of the socket and welded on the outside only. It is used for small-bore piping, 10A to 80A.WN (welding neck flange)All nominal pressures 5K to 63KIt is butt welded to the pipe. The joint is the strongest of all, and it is used for piping under high pressure, high temperature or repeated loading.LJ (lapped flange)Nominal pressure 5K, 10K, 16K, 20KIt is not fixed to the pipe but bears on the collar of a stub end. The flange turns freely, so lining up the holes is easy, and it can be a different material from the pipe.TR (threaded flange)Nominal pressure 5K, 10K, 16K, 20KThe pipe is screwed in with a taper pipe thread. It is used on sites where welding is not possible, and on lines where welding is unwanted. Only 10A to 150A are covered.IT (integral flange)Nominal pressure 5K, 10K, 16K, 20K, 30KA flange made in one piece with the body of a valve or a machine. It is not a separate part, so the table is consulted to match the joint dimensions to the mating side.BL (blind flange)All nominal pressures 5K to 63KA plate with no bore that closes the pipe end. It is used to stop a line off for testing, or for a branch to be added later.
A flange cast or forged as part of a valve or piece of equipment. It is not bought as a separate part, so these dimensions are used to match the joint to the flange it connects to. Available in nominal pressures 5K, 10K, 16K, 20K and 30K.
Integral flange dimensions
Notes
- References
- JIS B 2220:2012 steel pipe flanges (Table 14, Table 15, Table 17, Table 18, Table 19)
- The source has one table per nominal pressure. Here they are combined into a single table, with a rule where the nominal pressure changes. A dash means the dimension is not specified for that pressure. Selecting a single nominal pressure above drops the columns that do not apply, giving the same column layout as the source.
- The break line at the right of the drawing shows that the hub continues into the body of the valve or equipment. The small end of the hub a and the overall length T are set by the shape of that body, so the source does not specify them.
- The inside diameter d, the large end of the hub b and the fillet radius r are given in the source as reference values.
- No calculated mass is given, because Annex F does not cover integral flanges.
- The gasket seat is a raised face (RF) at every nominal pressure.
- Inside diameter d is adjusted to suit the inside diameter of the pipe it joins.